Driver Door Central Lock (Arm)/Unlock (Disarm) Switch Failure

Test 1 - 3:

Test 4 - 6:

SYMPTOM
DRIVER DOOR CENTRAL LOCK (ARM)/UNLOCK (DISARM) SWITCH FAILURE

WHEN MONITORED
Continuously.

SET CONDITION
If the BCM detect a signal on the Driver Cylinder Lock Switch Mux circuit for over 10 seconds this code will set and will ignore the offending input until it is corrected.

POSSIBLE CAUSES
- Binding driver cylinder lock switch
- Driver cylinder lock switch shorted to voltage
- Driver cylinder lock switch mux circuit shorted to voltage
- Wiring harness intermittent defect
- Body control module - driver cylinder lock switch failure