Child Restraint Anchor

WARNING: DURING, AND FOLLOWING, ANY CHILD RESTRAINT ANCHOR SERVICE, DUE TO IMPACT EVENT OR VEHICLE REPAIR, CAREFULLY INSPECT ALL MOUNTING HARDWARE, TETHER STRAPS AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. IF A CHILD RESTRAINT ANCHOR IS FOUND DAMAGED IN ANY WAY, THE ANCHOR MUST BE REPLACED.

REMOVAL
1. Remove the lower seat cushion.
2. Remove two nuts to LATCH bracket.
3. Remove bracket from vehicle.

INSTALLATION
1. Place LATCH bracket on studs and install retaining nuts. Torque nuts to 40 Nm (350 in. lbs.).
2. Install the rear seat cushion.