Resonator - Right Rear

RESONATOR RIGHT REAR (300M SPECIAL)

REMOVAL

WARNING: THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER WORK AROUND OR ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.

1. Raise vehicle on hoist.
2. Apply penetrating oil to right rear resonator/pipe nuts.

CAUTION: Do not use any tools to remove the isolators, remove by hand only. Soapy water or silicone-based spray may be used to assist removal. Do Not use a petroleum-based lubricant on the isolators. This will damage the rubber material.

3. Remove the rubber isolator from the rear support bracket on body.
4. Remove right rear resonator/pipe nuts.
5. Remove right rear resonator/pipe assembly.

INSTALLATION
1. Position right rear resonator/pipe assembly into mounting position. Loosely install attaching nuts.
2. Install the rubber isolator to the rear support bracket on body.
3. Align right rear resonator/pipe for proper clearance. Tighten nuts to 28 Nm (250 in. lbs.).