Sunroof / Moonroof: Adjustments

1. Move the sunshade rearward to the open position.
2. Move the sunroof glass panel to the fully dosed position.
3. Loosen the forward screws on each side enough to make the front adjustment.
4. Adjust the front of the sunroof glass panel 1mm (1/32 inch) below the top surface of the roof panel.
5. Tighten the front two screws.
6. Loosen the rear screws on each side enough to make the rear adjustment.
7. Adjust the rear of the sunroof glass panel 1mm (1/32 inch) above the top surface of the roof panel.
8. Tighten the rear two screws.
9. Check for proper fit. If not OK, repeat glass panel adjustment.