Speaker: Description and Operation

There are four different system combinations available on the LH models. They are a Base, Midline, Infinity 1, and Infinity 11 system.

BASE SYSTEM
The Base System includes:
- Two 6.5 inch round, full-range speakers in the front doors.
- Two 6 x 9-inch, full-range speakers mounted in the rear shelf panel.

MIDLINE SYSTEM
The Midline System includes:
- A compact 120 watt power amplifier with four output channels.
- Two 2.5 inch, round single-cone speakers in the lower front corners of the front door windows.
- Two 6.5 inch, round single-cone speakers in the front doors.
- Two 6 x 9-inch, full range speakers mounted in the rear shelf panel.

INFINITY I SYSTEM
The Infinity 1 System includes:
- A 240 watt Infinity power amplifier with six output channels
- One 2.5 inch, round single-cone, spatial imaging speaker in the center of the instrument panel.
- Two 2.5 inch round, single cone, spatial imaging speakers in the lower corners of the front door windows.
- Two 6.5 inch, round single-cone speakers in the front doors.
- Two 6 x 9-inch, single-cone speakers mounted in the rear shelf panel.

INFINITY II SYSTEM
The Infinity 11 System includes:
- A 360 watt power amplifier with nine output channels, one for each speaker location.
- One 2.5 inch, round single-cone, spatial imaging speaker in the center of the instrument panel.
- Two 2.5 inch round, single cone, spatial imaging speakers in the lower corners of the front door windows.
- Two 6.5 inch, round single-cone speakers in the front doors.
- Two 6 x 9-inch, single-cone speakers mounted in the rear shelf panel.
- Two 2.5 inch, round speakers mounted in the rear doors.

Two wires connected to each speaker, one feed circuit (+) and one return circuit (-), allow the audio output signal electrical current to flow through the voice coil. For complete circuit diagrams, refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.