Antenna Cable: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable
2. Inside trunk, pull passenger side trunk liner aside.
3. Unplug antenna lead from base of antenna mast.
4. Remove antenna mast by unscrewing mast from antenna body.
5. Remove screw from mounting bracket.
6. Pull antenna body down through the rubber grommet.

INSTALLATION
1. Push antenna body up through the rubber grommet in the quarter panel.
2. Install the screw to the mounting bracket.
3. Install antenna mast. Tighten to 2 N.m (15 in.lbs.). Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base.
4. Plug antenna lead into the antenna base.
5. Install the passenger side trunk liner.
6. Connect the battery negative cable.