Rear Door Trim Panel

REMOVAL
1. Open the rear door.
2. Using a trim stick, release clip attaching sail panel to the door.
3. Remove sail panel.

REMOVAL

CAUTION: Do not pry on door trim panel, damage to trim panel will result.

1. Open trim plug from the pull cup and remote bezel by inserting a small flat blade tool into the notch and lifting up.
2. Remove screw in the pull cup.
3. Remove screw in remote bezel.

r�::

4. Remove three screws from the bottom edge of door (REAR DOOR Trim PANEL TYPICAL).

NOTE: Clips are reusable up to three times.

5. Using a trim tool, disengage the retaining clips from the door trim panel to the sheet metal inner panel, two clips at the rear of panel and one at the front of the panel (REAR DOOR INNER TRIM PANEL TYPICAL).
6. Raise trim panel up over the door flange and being careful to hold the panel securely.

CAUTION: Failure to hold the door trim panel before disengagement of the linkage will result in remote handle damage.

7. Disconnect the remote linkage from the door remote handle.
8. Remove the wire connect from the rear door speaker, if equipped.
9. Disconnect power window switch wire connector.
10. Disconnect wiring harness clips from the trim panel.
11. Remove trim panel from door.

�::

REMOVAL WOOD TRIM
1. Remove door trim panel.
2. Remove and discard the retainer clips (WOOD TRIM CLIPS TYPICAL)
3. Remove the wood trim from the trim panel.(WOOD TRIM_TYPICAL).

INSTALLATION
1. Place trim panel in position on door.
2. Connect the wiring harness clips to the trim panel.
3. Connect the power window switch wire harness connector.
4. Connect the rear door speaker wire connect.
5. Connect the remote handle linkage.
6. Hook the trim panel over the sheet metal flange.
7. Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
8. Engage the three retaining clips to attach door trim panel to door sheet metal inner panel, up to three ratchet clicks.
9. Install three screws to the bottom of the door. Tighten all screws 1.3 to 1.9 Nm (12 to 17 in. lbs.) torque.
10. Install screw in the remote bezel and close the trim plug.
11. Install screw in pull cup, and close the trim plug

�::

INSTALLATION WOOD TRIM
1. Install wood trim into mounting hole ofthe trim panel (WOOD TRIM TYPICAL).
2. Install new retainer clips and seat fully (WOOD TRIM CLIPS TYPICAL).
3. Install the door trim panel.