FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Exhaust Manifold - Right

EXHAUST MANIFOLD RIGHT

REMOVAL
1. Disconnect negative cable from remote jumper terminal.
2. Raise vehicle on hoist.
3. Remove the exhaust system.
4. Loosen converter pipe support attaching bolt at transaxle mount.
5. Loosen the A/C belt.
6. Lower vehicle.
7. Remove air cleaner housing and air inlet tube.
8. Loosen and remove V-Band clamp at exhaust manifold connector.

NOTE: Do not reuse V-Band clamp.

9. Remove the A/C compressor attaching bolts and set compressor aside.
10. Remove engine oil dipstick tube.
11. Remove the A/C compressor bracket.
12. Disconnect oxygen sensor electrical connector and remove sensor.





13. Remove heat shield attaching bolts and remove heat shields.





14. Remove the exhaust manifold attaching bolts.
15. Remove the exhaust manifold and gasket.

INSPECTION
1. Inspect exhaust manifolds for damage or cracks.
2. Check manifold flatness.
3. Inspect the exhaust manifold gasket for obvious discoloration or distortion.
4. Check distortion of the cylinder head mounting surface with a straightedge and thickness gauge.

INSTALLATION
1. Install exhaust manifold and gasket. Tighten bolts starting at the center working outward to 23 Nm (200 in. lbs.).
2. Install heat shields and tighten attaching bolts to 12 Nm (105 in. lbs.).
3. Install oxygen sensor to manifold and connect electrical connector.
4. Install the A/C compressor mounting bracket.
5. Install engine oil dipstick tube.
6. Install the A/C compressor and drive belt.
7. Install a new V-Band clamp and tighten to 11 Nm (100 in. lbs.).
8. Raise vehicle on hoist.
9. Install the exhaust system.
10. Install and/or tighten nut attaching converter pipe support to transaxle mount to 47 Nm (35 ft. lbs.).
11. Lower the vehicle.
12. Install air cleaner housing and air inlet tube.
13. Connect negative cable.