Power Steering Fluid Reservoir: Service and Repair
RESERVOIRREMOVAL
1. Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
2. Remove screw fastening reservoir to engine coolant recovery bottle.
3. Lift reservoir off guide on engine coolant recovery bottle.
4. Remove hose clamps attaching power steering fluid supply hose and return hose to reservoir.
5. Remove power steering fluid supply and return hoses from reservoir and remove reservoir from vehicle.
INSTALLATION
1. Install power steering fluid return and supply hoses on power steering fluid reservoir fittings. Be sure both hose clamps are installed on hose past upset bead on power steering reservoir fittings.
2. Slide reservoir down over guide on engine coolant recovery bottle.
3. Install power steering fluid reservoir mounting screw and tighten to 6 Nm (53 inch lbs.).
4. Fill power steering pump fluid reservoir to the proper level.
5. Start the engine and let run for a few seconds, then turn the engine off.
6. Adjust fluid level if necessary. Repeat steps 5. and 6. until the fluid level remains constant after running the engine. If necessary perform Power Steering Pump Initial Operation standard procedure.
7. Check for leaks.