Non-Trouble Code Diagnostic Procedures
STANDARD PROCEDURE-INSPECTION - AIRBAG SYSTEM MAINTENANCECheck the airbag warning lamp for proper operation as follows:
1. Turn the ignition switch to the ON position. The airbag warning lamp should illuminate. If it does not, test the system using a DRB III scan tool and Body Diagnostic Procedures Manual. Repair as required. Erase stored DTC's.
2. The airbag warning lamp lights, but fails to go out after ten seconds.Test the system using a DRB III scan tool and the proper Body Diagnostic Procedures manual Repair as required. Erasing stored Diagnostic Trouble Codes (DTC's) is not required.