P0755

Symptoms:
P0755-2/4 SOLENOID CIRCUIT

When Monitored and Set Condition: P0755-2/4 SOLENOID CIRCUIT
When monitored: initially at power-up, then every 10 seconds thereafter. They will also be tested immediately after a Gear Ratio or Pressure Switch error is detected.
Set condition: Three consecutive Solenoid continuity test failures, or one failure if test is run in response to a Gear Ratio or Pressure Switch error.

POSSIBLE CAUSES:
RELATED RELAY DTC'S PRESENT
INTERMITTENT WIRING AND CONNECTORS
TRANSMISSION CONTROL RELAY OUTPUT CIRCUIT OPEN
2/4 SOLENOID CONTROL CIRCUIT OPEN
2/4 SOLENOID CONTROL CIRCUIT SHORT TO GROUND
2/4 SOLENOID CONTROL CIRCUIT SHORT TO VOLTAGE
2/4 SOLENOID
TCM - 2/4 SOLENOID