Rear - JR27 Only

Rear Seat Belt and Retractor-JR27 Only

REMOVAL
1. Disconnect and isolate the battery negative cable
2. Remove rear seat cushion Refer to Body, Seats, Rear Seat Cushion, Removal.
3. Remove rear seat back. Refer to Body, Seats, Rear Seat Back, Removal.
4. Remove quarter trim panel. Refer to Body Interior, Lower Quarter Trim Panel, Removal.

Fig. 3 Rear Seat Belt And Retractor:

5. Remove bolt attaching seat belt anchor to floor pan.
6. Remove bolt attaching seat belt retractor to rear seat support assembly.
7. Remove rear seat belt and retractor assembly from vehicle.

INSTALLATION
1. Position rear seat belt and retractor assembly to rear seat support assembly.
2. Engage hook on seat belt retractor to slot in rear seat support assembly.
3. Install bolt attaching seat belt retractor to rear seat support assembly. Tighten seat belt fastener to 40 Nm (350 in. lbs.) torque.
4. Route seat belt through channel and snap bezel onto top of channel.
5. Install bolt attaching seat belt anchor to floor pan. Tighten seat belt fastener to 40 Nm (350 in. lbs.) torque.
6. Verify that seat belt is not twisted when engaged to seat belt buckle and that the tab on the lower seat belt anchor is between the formations on the floor pan.
7. Install quarter trim panel. Refer to Body, Interior, Lower Quarter Trim Panel, Installation.
8. Install rear seat back. Refer to Body, Seats, Rear Seat Back, Installation.
9. Install rear seat cushion. Refer to Body, Seats, Rear Seat Cushion, Installation.
10. Connect the battery negative cable.