Antenna: Service and Repair

POWER ANTENNA - BUX

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disconnect drain tube.
3. Disconnect electrical connector.
4. Disconnect antenna cable.
5. Remove ground strap fastener (if equipped).

Fig.3 Power Antenna - Typical:

6. Remove mounting bolts from antenna.
7. Pull antenna through grommet in quarter panel.

INSTALLATION
1. Push antenna up through grommet in quarter panel.
2. Install mounting bolts to antenna. Tighten to 12 Nm (110 in. lbs.).
3. Connect antenna cable.
4. Connect electrical connector to antenna.
5. Connect drain tube.
6. Install ground strap (if equipped) and fastener. Tighten to 12 Nm (110 in. lbs.).
7. Connect battery negative cable.