Front Door Outer Belt Molding

FRONT DOOR OUTER BELT MOLDING

REMOVAL

Fig. 10:

1. Remove screw attaching rearward end of molding to front door (Fig. 10).

Fig. 11:

2. Using a rubber mallet and block of wood, tap upward at each clip attaching belt molding to door (Fig. 11).
3. Lift up on the rear of the belt molding and pull rearward to remove.

INSTALLATION

1. Place belt molding in position.
2. Using your hand press downward at each clip attaching belt molding to door till in position.
3. Install screw attaching rearward end of molding to front door.