30RH, 30TH, 31TH, 32RH, 36RH, 42RE/RH, 46RE/RH, 47RE and 48RE

1. Remove fluid using approved Team PSE Automatic Transmission Fluid X-changer or equivalent.

2. Remove torque converter (keep with unit).

3. Measure input shaft end play.

4. Remove pump assembly.

5. Loosen front band adjustment screw until link can be removed (keep link with unit).

6. Rotate front band and remove (keep with unit).

7. Remove front clutch retainer and rear clutch retainer assembly.

8. Remove intermediate shaft snap ring (keep with unit).

9. Remove front and rear planetary assemblies and drive shell (keep with unit).

10. Remove low/reverse drum snap rings.

11. Remove low/reverse drum.

12. Remove overdrive unit.

13. Remove overdrive clutch snap ring.

14. Remove overdrive clutch disc and plates.

15. Remove overdrive wave spring.

16. Remove overdrive snap ring.

17. Remove access cover and gasket.

18. Expand output shaft bearing snap-ring with expanding type snap ring pliers. Then push output shaft forward to release shaft bearing from locating ring.

19. Remove geartrain assembly.

20. If transmission is determined to be greater than 70% failed follow steps 21 through 24. If transmission is determined to be less than 70% failed, refer to the service information available in TechCONNECT or the appropriate service manual in Section 21 for detailed repair instructions.

21. Drop band adjustment link in pan.

22. Reassemble transmission by reversing steps 4 through 19.

23. Return the old torque converter using the same method used to ship to dealer. If the service unit was received with the converter in a separate box within the transmission package, return the failed unit in this manner. Otherwise, place converter into trans and install shipping strap and bolts.

24. Return any loose items by attaching to bellhousing in plastic bag.

NOTE:
All parts must be returned with transmission.

NOTE:
For detailed information, Refer to TechCONNECT 21 - TRANSMISSION AND TRANSFER CASE or the appropriate service manual in Section 21 for specific information regarding disassembly and repair procedures.