Trunk / Liftgate Switch: Service and Repair

DECKLID RELEASE SWITCH

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove left lower instrument panel cover. Refer to Body, Instrument Panel, Left Lower Instrument Panel Trim, Removal.
3. Disconnect the wire connector.
4. Pinch four tabs around side of decklid release switch on the rear side of the left lower instrument panel trim, and push switch through opening.

INSTALLATION
1. Position the decklid release switch over opening of the left lower instrument panel trim, and push switch through opening.
2. Connect the wire connector.
3. Install the left lower instrument panel cover. Refer to Body Instrument Panel, Left Lower Instrument Panel Trim, Installation.
4. Connect the negative battery cable remote terminal to the remote battery post.