Seat Belt & Retractor - Front Outboard

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove adjuster knob and turning loop cover.
3. Remove bolt that attaches the turning loop to the height adjuster.
4. Remove upper B-pillar trim panel.
5. Remove the lower B-pillar trim panel.
6. Disconnect the wire harness connector from the B-pillar retractor.
7. Remove the bolt attaching the seat belt retractor (and lower anchor) to the base of the B-pillar.
8. Remove retractor and belt from vehicle.

INSTALLATION
1. Place retractor and belt into position.
2. Install bolt attaching seat belt retractor and lower anchor to the base of the B-pillar. Torque bolt to 55 ± 5 Nm (40.5 ft. lbs.).
3. Connect retractor wire harness connector to the B-pillar.
4. Route belt and install the lower B-pillar trim panel.
5. Install the upper B-pillar trim and bolt that attaches the turning loop to the height adjuster. Torque bolt to 55 ± 5 Nm (40.5 ft. lbs.).
6. Install the turning loop cover and adjuster knob.
7. Connect the battery negative remote cable.