Driver Airbag

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post. Wait two minutes for the capacitor to discharge.
2. Remove speed control switch screws from steering wheel back cover, remove switches and disconnect the wires.
3. Remove two bolts retaining Driver Airbag.

Fig.1 Connector Positive Assurance (CPA) Connector:

4. Lift airbag and disconnect the two Connector Positive Assurance (CPA) airbag initiators, and horn switch wire connectors.
5. Remove Driver Airbag from vehicle.

WARNING: WHEN REPLACING A DEPLOYED DRIVER AIRBAG, THE CLOCK SPRING MUST ALSO BE REPLACED. REFER TO ELECTRICAL, RESTRAINTS, CLOCK SPRING, REMOVAL , AND INSTALLATION.


INSTALLATION
1. With the battery disconnected, connect the lead wire from the clock spring to the horn switch and both airbag initiator connectors. The airbag initiator connectors are color-coded. The grey connector from the clock spring goes to the grey connector on the air- bag, and the black connector goes to the black connector on the airbag.
2. Install the two torx bolts holding the driver air- bag. torque to 9.6 ± 1 Nm (85 ± 10 in. lbs.).
3. Connect the wire connectors to the speed control switches and install switches. Torque the speed control switch mounting screws to 1.5 Nm (13 in. lbs).

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE REMOTE TERMINAL. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST.