Seat Track: Testing and Inspection

1. Remove power seat switch from seat.
2. Disconnect wire harness connector.
3. Check Pin 1 for battery voltage and Pin 5 for ground. On convertible models refer to step 5.

Switch Harness Connector Circuit Test:

Fig.4 Switch Harness Connector:

4. To test the seat motors, refer to the, and verify proper seat responses. Using two jumper wires, connect one to a battery supply and the second to a ground. Connect the other ends to the seat wire harness connector as described in the Switch Harness Connector Circuit Test table.

Fig. 4 Seat Switch Electrical Connector:

5. Using a voltmeter, connect the ground lead to PIN B of the switch harness connector. Connect the positive lead to PIN A. If battery voltage is present, the ground and voltage circuits to the power seat switch are OK. Check the power seat switch for proper operation (Refer to ELECTRICAL/POWER SEATS/DRIVER SEAT SWITCH - DIAGNOSIS AND TESTING). If the seat switch checks out OK, remove the seat assembly and check the circuits from the power seat switch to the power seat track adjuster motors for proper continuity. If the circuits appear to be OK, replace the power seat track and adjuster motors as an assembly.