Trunk / Liftgate Solenoid: Service and Repair

DECKLID RELEASE SOLENOID
REMOVAL
1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
2. Raise deck lid to the full up position.
3. Remove latch cover push pins then remove cover.
4. Remove two retaining nuts to latch and motor, then remove latch and motor assembly.

INSTALLATION
1. Install the latch and motor assembly. Install the two retaining nuts.
2. Install latch cover and push pins.
3. Close the deck lid.
4. Connect the negative battery cable remote terminal to the remote battery post.