Manual Transmission/Transaxle: Application and ID

T350 MANUAL TRANSAXLE
TRANSAXLE IDENTIFICATION








The transaxle model, assembly number, and build date are on a metal I.D. tag that is attached to the end cover of the transaxle (Fig. 2). This information is also shown on a bar code label that is attached to the front of the transaxle (Fig. 3).


LUBRICANT/ADDITIVES
NV T350 (A-578) transaxles use Mopar ATF +4 (Automatic Transmission Fluid - Type 9602). Hypoid gear lube or engine oil should not be used in this transaxle. Hard shifting effort, bearing, gear, and/or synchronizer failure may occur if incorrect fluid is used.
The addition of any fluids to the transaxle, other than the fluid listed above, is not recommended. An exception to this policy is the use of special dyes to aid in detecting fluid leaks. The use of transmission sealers should be avoided, since they may adversely affect seals.

SEALANTS
The sealant used to seal the transaxle case halves and input bearing is Mopar Gasket Maker, Loctite 518, or equivalent. The sealant used for the bearing end plate cover is Mopar RTV.