Seat Belt and Retractor - Rear Center Three Point

REMOVAL
1. Remove rear seat cushion and back
2. Remove seat belt bezel from parcel shelf cover.
3. Remove two push fasteners to NVH cover over retractor.
4. Remove bolt attaching retractor to floor.
5. Remove bolt attaching seat belt lower anchor to floor.
6. Push seat belt bezel and buckle stab through access hole in parcel shelf.
7. From in trunk compartment, remove rear seat belt retractor from vehicle.

INSTALLATION
1. Position rear seat belt retractor in trunk compartment.
2. Push seat belt bezel and buckle stab through access hole in rear shelf trim panel.
3. Install bolt attaching retractor to rear floor. Tighten to 40 Nm (30 ft. lbs.) torque.
4. Install the NVH cover and two push fasteners over the center retractor.
5. Install bolt attaching seat belt lower anchor to floor. Tighten the seat belt bolt to 57 Nm (42 ft. lbs.) torque.
6. Install seat belt bezel to the rear shelf trim panel.
7. Install rear seat cushion and back.