Washer Reservoir Replacement

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for REMOVAL.
4. Disconnect the wire connectors from the reservoir pump and float sensor.
5. Disconnect the washer hose and block the liquid outlet to prevent the liquid from running out of the reservoir.
6. Reach up behind the washer reservoir and pull the filler tube off the rear of the reservoir.

Washer Reservoir Removal:

7. Remove four mounting bolts to washer reservoir
8. Remove washer reservoir from vehicle.

Fig. 10 Washer Reservoir:

9. Transfer fluid level sensor, pump, and washer fluid to new reservoir

INSTALLATION
1. Transfer fluid level sensor, pump, and washer fluid to new reservoir
2. Place washer reservoir into vehicle into the mounting position.
3. Install the four mounting bolts to the washer reservoir
4. Reach up behind the washer reservoir and place the filler tube onto the rear of the reservoir.
5. Connect the washer hose to the washer pump outlet.
6. Connect the wire connectors to the reservoir pump and float sensor.
7. Install the front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for INSTALLATION.
8. Lower vehicle from hoist.
9. Connect the negative battery cable remote terminal to the remote battery post.