Wiper and Washer Systems: Service and Repair

STANDARD PROCEDURE - HEADLAMP WASHER SYSTEM PRIMING - EXPORT
The headlamp washer system may loose it's prime when the system is serviced. The following procedure must be used to prime the headlamp washer system. A DRB III scan tool must be used for this priming procedure.

Do not allow washer fluid to spray on hot engine with the hood up.

Do not stand near the headlamp washer nozzles when actuating the headlamp washer system. The washer fluid comes out of the nozzles at high pressure.

1. Connect a DRB III scan tool.
2. Go to the "BODY" menu.
3. Go to the "ACTUATOR" menu.
4. Actuate the "HEADLAMP WASHER" actuator until the headlamp washer system is properly primed.

Do not actuate the headlamp washers longer that 4 seconds at a time. Allow pump to cool prior to next attempt. Damage to the headlamp washer pump may occur.