Rear

REMOVAL - HUB AND BEARING (REAR)
1. Raise vehicle on jack stands or centered on a frame contact hoist.
2. Remove the rear wheel and tire assembly from the vehicle.





3. Remove the rear caliper assembly from the adapter. After removing caliper assembly, store caliper by hanging it from frame of vehicle. Do not let weight of rear caliper assembly hang from flexible brake hose.
4. Remove rear brake rotor from hub.





5. Remove rear hub and bearing assembly cotter pin and nut retainer. Remove the hub and bearing retaining nut and washer from the spindle. Remove hub and bearing assembly from spindle.

INSTALLATION - HUB AND BEARING (REAR)





1. Install the rear hub and bearing assembly on the rear spindle. Install hub and bearing assembly retaining washer and nut on spindle. Tighten the hub and bearing retaining nut to a torque of 168 Nm (124 ft. lbs.). Install the nut retainer and cotter pin.
2. Install the rear brake rotor on the hub.
3. Carefully place rear brake caliper over rotor and install on adapter.
4. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
5. Lower vehicle to the ground.