Glove Box Lamp: Service and Repair

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Open the glove box door, using a trim stick (special tool #C-4755) or equivalent, gently pry out on the glove box lamp/switch assembly from upper right hand corner of opening.
3. Pull defective bulb out of lamp socket.

INSTALLATION
1. Push replacement bulb into the lamp socket.
2. Place glove box lamp/switch assembly into position, firmly snap into place, and close the glove box door
3. Connect the negative battery cable remote terminal to the remote battery post.