Trunk / Liftgate Switch: Service and Repair

DECK LID RELEASE SWITCH

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove left lower instrument panel cover. Refer to Body Instrument Panel, Instrument Panel and Pad Assembly, REMOVAL and INSTALLATION.
3. Pinch four tabs around side of decklid release switch on the rear side of the left lower instrument panel cover, and push switch through opening.

INSTALLATION
1. push switch through opening and firmly snap into place on the left lower instrument panel cover.
2. Install the left lower instrument panel cover. Refer to Body Instrument Panel Instrument Panel and Pad Assembly, REMOVAL and INSTALLATION.
3. Connect the negative battery cable remote terminal to the remote battery post.