Trunk / Liftgate Solenoid: Service and Repair

DECK LID RELEASE SOLENOID

REMOVAL
1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
2. Raise deck lid to the full up position.
3. Remove latch cover attaching screws then remove cover.
4. Remove two mounting motor screws and remote key cable retainers then remove motor.

INSTALLATION
1. Install the two mounting motor screws and remote key cable retainers and motor.
2. Install the cover and latch cover attaching screws.
3. Connect and isolate the negative battery cable remote terminal onto the remote battery post.
4. Close the deck lid.