Trip Computer: Service and Repair

REMOVAL
1. Remove overhead console (Refer to ELECTRICAL/OVERHEAD CONSOLE - REMOVAL).

OTIS Removal:

2. Remove mounting screws and release the map lamp wire connector from the Compass Mini-Trip Computer.
3. Remove the Compass Mini-Trip Computer from overhead console.

INSTALLATION
1. Position the Compass Mini-Trip Computer and install the retaining screws.
2. Connect the Compass Mini-Trip Computer electrical connector. Make sure the wire that was clipped into the module housing is properly clipped into the new module before the overhead console is placed back into the headliner.
3. Install the overhead console (Refer to ELECTRICAL/OVERHEAD CONSOLE - INSTALLATION).