Sunroof / Moonroof Motor: Service and Repair
REMOVAL SERVICE POINTS<>SUNROOF MOTOR REMOVAL
CAUTION: Always close the roof lid glass fully before removing the sunroof motor. If the fully-closed positions of the roof lid glass and the sunroof motor are not the same, the sunroof will not operate properly.
NOTE: If there is a problem with the sunroof motor so that the roof lid glass cannot close fully use an Allen wrench to turn the gear section of the sunroof motor to fully close the roof lid glass.
<>SUNROOF MOTOR ASSEMBLY INSTALLATION
If the sunroof motor assembly is out of its fully closed position, adjust the motor position by the following steps before installing it.
1. Remove the sunroof motor assembly without disconnecting the sunroof motor assembly connector.
2. Close the sunroof lid glass fully.
3. Push the sunroof close switch until the sunroof motor assembly stops turning. Repeat this operation until the motor does not turn at all. Then install the motor assembly to the roof.
NOTE: When the sunroof motor assembly does not turn at all, the sunroof-ECU will return to its default condition.