Instrument Panel Storage Bin Replacement

CUBBY BIN/LAMP

REMOVAL
1. Disconnect and isolate the battery negative cable remote terminal from the shock tower.
2. Remove center bezel.
3. Remove instrument cluster hood screws.
a. Remove two screws adjacent radio.
b. Remove screw below HVAC control in the center.
c. Remove screw at left end of panel.
d. Flex instrument cluster hood slightly to give access to the cubby bin screws.
4. Remove the cubby bin mounting screws and remove bin.


INSTALLATION
1. The cubby bin must engage the console at its forward edge prior to installing the mounting screws.
2. Position bin in instrument panel.
3. Install the retaining screws.
4. Install instrument panel cluster.
5. Install panel cluster screws.
6. Install center bezel.