Wiper Motor: Service and Repair

REMOVAL
1. Remove wiper module.
2. Remove linkage from motor crank. Insert screwdriver or equivalent between crank and linkage then twist and lift straight up on linkage.
3. Remove three motor mounting screws and separate motor from linkage.

INSTALLATION
For installation and reverse the above procedures.
1. Attach motor to linkage. Install the three motor mounting screws and tighten the motor mounting screws to 5 to 6 Nm (45 to 55 in. lbs.) torque.

NOTE: If motor crank was taken oft for any reason, install and tighten drive link nut to 11 to 12 Nm (98 to 106 in. lbs.) torque.

2. Add unilube grease to the linkage socket and install the linkage onto the motor crank.
3. Install the wiper module.