Backup Lamp Switch: Service and Repair

REMOVAL
1. Lift vehicle on hoist

Fig.1 Back-Up Lamp Switch:

2. From bottom side of vehicle, disconnect backup lamp switch connector.
3. Unscrew switch from transaxle.

INSTALLATION
1. Install back-up lamp switch. Teflon tape or equivalent must be used on switch threads. Tighter switch to 24 Nm (18 ft. lbs.) torque.

CAUTION: Do not over tighten switch.

2. Connect back-up lamp switch connector.
3. Lower vehicle.
4. Verify back-up lamp operation.