Mirrors: Testing and Inspection

1. Remove front door trim panel.
2. Disconnect wire connector.
3. Use two jumper wires. One connected to a 12 volt source, and the other to a good body ground.
4. Apply the grounded jumper wire to pin 3 of the mirror connector, then start with pin 2 (horizontal movement), pin 5, and then pin 1 for the heated mirror.
5. If test results are not obtained as expected, check for an open or shorted circuit, or replace mirror assembly as necessary
Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.