ACM Loss of Ignition Run/Start (Stored)

Test 1:

SYMPTOM
ACM, LOSS OF IGNITION RUN-START - STORED

TEST NOTE
This symptom is diagnosed using the test ACM, CLUSTER MESSAGE MISMATCH - STORED.

WHEN MONITORED
With the ignition in the Run-Start position the ACM monitors the Fused Ignition Switch Output Run-Start circuit for proper system voltage.

SET CONDITION
If the voltage on the Fused Ignition Switch Output Run-Start circuit drops below approximately 4.5 volts, the code will set.

POSSIBLE CAUSES
- Active or stored code present
- Stored code or intermittent condition