Windshield Washer Motor: Service and Repair

REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the left headlamp assembly and set aside. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit (In this engine), Removal.

Washer Reservoir Removal:

3. Remove the four retaining bolts to the washer reservoir.
4. Disconnect the pump and sensor wire connectors.
5. Disconnect the washer hose.
6. Disconnect the washer filler hose.
7. Pivot the inboard side of the reservoir forward and lift out of vehicle.

Fig.6 Washer Reservoir:

8. Carefully pull the pump out of the reservoir.

NOTE: When replacing the pump, make sure to use a new grommet for proper sealing and to avoid leaks.

INSTALLATION

NOTE: When replacing the pump, make sure to use a new grommet for proper sealing and to avoid leaks.

1. Install the new pump grommet.
2. Position pump motor over grommet and firmly snap into place.
3. Place reservoir into position in engine compartment, pivot the inboard side of the reservoir rearward.
4. Connect the washer filler hose.
5. Connect the washer hose.
6. Connect the pump and sensor wire connectors.
7. Install the four retaining bolts to the washer reservoir.
8. Install the left headlamp assembly. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit (In this engine), Installation.
9. Connect the negative battery cable remote terminal to the remote battery post.