Fuse Block: Service and Repair

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

Junction Block/BCM Location:

The Junction Block (JB) and Body Control Module (BCM) are attached to each other. After removal they can be separated. Junction Block and Body Control Module assemblies are located on the driver's side of the vehicle.
connectors are in good condition and connectors are properly installed.

Junction Block Location:

1. Open hood then disconnect and isolate the battery negative remote cable from the remote terminal on the left shock tower.
2. Open the front driver's door and remove end cap.
3. Remove center bezel.
4. Remove instrument cluster hood.
5. Remove silencer.
6. Remove wire harness connectors from Junction Block.
7. Remove Junction Block three mounting screws.
8. Remove Junction Block/BCM by pulling straight down from the mounting bayonet.
9. Disconnect BCM wire connectors and remove the assembly.
10. Remove Junction Block/BCM from vehicle.
11. With the Junction Block/BCM removed from the vehicle, separate the BCM from the Junction Block.
12. Remove the two BCM attaching screws and release the two BCM locking latches from the Junction Block.
13. Disconnect BCM from the Junction Block.

INSTALLATION
For installation, reverse the above procedures. Ensure that the wire terminals and connectors are in good condition and connectors are properly installed.