Console: Service and Repair

FLOOR CONSOLE

REMOVAL


1. Raise parking brake lever as high as possible.
2. Move transmission shifter to neutral position.
3. Loosen set screw on front of shifter knob and remove shift lever knob.
4. Remove lighted transmission range indicator letter bezel.
5. Disconnect transmission range indicator bezel wire connector at the shifter mechanism.
6. Remove screws, next to floor shifter and in console storage compartment, attaching floor console to brackets on floor pan.
7. Disconnect wire connector for floor console accessories at floor pan.
8. Remove console from vehicle

NOTE: The grip portion of the parking brake lever will only fit through the wider lower portion of the slot in the floor console.


INSTALLATION

1. Position console in vehicle.
2. Connect wire connector for floor console accessories at floor pan.
3. Verify that the rear locator pin on the bottom of the storage bin is engaged to the slot in the body bracket and the front pin is engaged to the shift mechanism.
4. Install screws, next to floor shifter and in console storage compartment, holding floor console to brackets on floor pan.
5. Connect transmission range indicator bezel wire connector on shifter mechanism.
6. Install lighted transmission range indicator letter bezel.
7. Install shift lever knob and tighten set screw on front of shifter knob.