Verification Test VER-5A3

VERIFICATION TEST VER-5A3

Applicability - All

1. OBD II Monitor Verification.

2. With the DRB III, monitor the pre-test enabling conditions until all conditions have been met to run the appropriate monitor. Run the appropriate monitor for the repaired DTC.

3. If the repaired OBD II trouble code has reset, or the OBD II monitor failed after running, the repair is not complete. Check for any technical service bulletins or flash updates and return to Symptom List.

4. If a new DTC has set, return to Symptom List and perform the tests specified for that code.

5. If the monitor ran, and the Good Trip counter changed to one or more, the repair was successful.

6. Erase trouble codes.

7. Disconnect the DRB III.