Wiper Arm: Service and Repair

REMOVAL
1. Place the wiper arm/blades in the PARK position and turn ignition OFF.
2. Using a trim stick (special tool # C-4755), gently pry up on arm cap and remove.
3. Remove wiper arm retaining nut.
4. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position.
5. Clean metal splinters OFF the pivot shafts.

INSTALLATION
For installation reverse above procedures. Before installation activate wiper system to ensure the wiper module is in the PARK position. Position wiper arms so that the heel of the blade(s) is on the park line on the windshield. Refer to Adjustments for Wiper Arm Adjustment.