Rear Door Window Glass: Service and Repair

DOOR GLASS

REMOVAL

1. Remove door trim panel and inner belt weatherstrip.
2. Lower the window to 50 mm (2 ins.) from bottom of travel.

Fig. 3:

3. Loosen bolts attaching rear lower run channel to inner door panel (Fig. 3).
4. Remove rear run channel from door.
5. Loosen screws attaching window regulator channel to glass.
6. Slide channel rearward to allow screw heads to pass through key hole slots in channel.
7. Remove glass from roller channel.
8. Lift door glass upward out of the opening at the top of door.

INSTALLATION

1. Lower door glass through opening in top of door and into position in the window regulator.
2. Position door glass onto roller channel.
3. Slide roller channel forward to allow screw heads to engage key hole slots in channel.
4. Tighten screws attaching window regulator roller channel to glass.
5. Install inner door belt door trim panel inner belt weatherstrip.
6. Operate window and check for interference. Adjust glass as necessary.