Clutch Switch: Service and Repair

REMOVAL
1. Disconnect and isolate battery negative cable.
2. Remove instrument panel assembly.

Fig. 9:

3. Disconnect the clutch interlock/upstop switch connector (Fig. 9).

NOTE: Proper switch harness routing is critical to switch durability. Note the harness routing and location of fasteners intended to keep wires from contacting pedals.

4. Remove the interlock/upstop switch assembly from the brake/clutch pedal bracket assembly by depressing the four plastic wing tabs on each switch.

INSTALLATION
1. Install switches into the pedal bracket assembly as shown in (Fig. 9). Route harness as was prior to removal.
2. Connect interlock/upstop switch connector.
3. Install instrument panel assembly.
4. Connect battery negative cable.
5. Verify proper switch operation.