Sunroof Module Assembly
REMOVAL1. Close glass panel, if possible
2. Remove A-pillar trim.
3. Remove upper B-pillar and C-pillar trim.
Fig. 1 Sunroof Components:
4. Remove sunroof welt.
5. Remove the switch.
6. Detach fastener from headlinder bracket to the front beam.
7. Remove all assist handles.
8. Remove sun visors.
9. Remove headlining and disconnect the dome lamp connector.
10. Disconnect sunroof motor wiring connector.
11. Disconnect drain tubes.
12. Remove fasteners attaching sunroof module to vehicle roof.
13. With the aid of a helper, remove sunroof module from roof.
14. Remove sunroof module from vehicle.
INSTALLATION
1. With the aid of a helper, position sunroof module in vehicle.
2. Install fasteners attaching sunroof module to vehicle roof and support braces. Tighten all fasteners to 5 Nm (44 in. lbs.), starting from the front and working rearward and then the motor bracket.
3. Connect drain tubes.
4. Connect sunroof motor wiring connector.
5. Headliner in position connect dome lamp wire connector. Install headlining.
6. Install the fastener from the headliner bracket to front beam.
7. Install switch.
8. Install sunroof welt.
9. Install B-pillar and C-pillar trim.
10. Install A-pillar trim.
11. Install sun visors.
12. Install all assist handles.
13. Install sunroof sunshade.
14. Install sunroof glass panel.
15. Cycle glass panel open and close.
16. Ensure glass adjustment, refer to Glass Adjustment procedure
17. Verify correct operation.