Engine Control Module: Service and Repair

REMOVAL

Battery Cable:

1. Disconnect the negative battery cable.
2. Remove the air cleaner box, refer to the air cleaner box.

Powertrain Control Module(PCM):

3. Remove the gray and black connector from the PCM.

PCM Wiring Bracket:

4. Remove the harness clip bracket from PCM bracket.
5. Remove the nut from the upper bracket mount.
6. Raise vehicle and support on hoist.

Lower Mounting Bolts:

7. Remove 2 lower bracket bolts.

PCM Bracket Screws:

8. Remove 4 screws from bracket and remove bracket from PCM.

INSTALLATION
1. Install bracket to PCM and tighten screws.
2. Install PCM and bracket to body and tighten the 2 lower bolts.
3. Lower vehicle.
4. Install upper bracket nut and tighten.
5. Clip in wiring harness bracket.
6. Install gray and black connectors to the PCM.
7. Install the air cleaner box, refer to the air cleaner box.
8. Connect the negative battery cable.