Accessory Switch Bezel

ACCESSORY SWITCH BEZEL

REMOVAL

Fig. 1:

1. Disconnect and isolate the battery negative cable (Fig. 1).
2. Remove the instrument panel center bezel.

Fig. 2:

3. Remove four screws retaining accessory switch bezel (Fig. 2).
4. Disconnect the harness connectors to the following:
- Rear Window Defogger Switch (if equipped)
- Traction Control Switch (if equipped)
- Cigar Lighter/Power Outlet

The accessory switches are not serviced separately, but the cigar lighter/power outlet is and must be transferred to the new bezel.

INSTALLATION

The accessory switches are not serviced separately, but the cigar lighter/power outlet is and must be transferred to the new bezel.

1. Connect the harness connectors to the following:
- Cigar Lighter/Power Outlet
- Traction Control Switch (if equipped)
- Rear Window Defogger Switch (if equipped)

2. Install the four screws retaining the accessory switch bezel (Fig. 2).
3. Install the instrument panel center bezel.
4. Connect the battery negative cable (Fig. 1).