Removal and Installation

All models use a single speed electric motor driven cooling system fan. The fan module includes a motor, fan blade, and support shroud. The module is fastened to the radiator by screws.

REMOVAL

WARNING: DO NOT REMOVE THE CYLINDER BLOCK PLUG OR THE RADIATOR DRAINCOCK WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.

1. Disconnect negative cable from battery.
2. Drain cooling system below upper radiator hose level.






3. Remove upper radiator hose from radiator.
4. Disconnect fan module electrical connector.






6. Remove fan module screws from radiator.
6. Lift fan shroud up and out of lower shroud attachment clips.
7. Refer to Disassembly and Assembly for fan module sub-component service procedures.

INSTALLATION
1. Install the fan module into the clips on the lower radiator tank.
2. Install the fan module retaining screws and tighten to 7.5 Nm (65 inch lbs.).
3. Connect fan module electrical connector.
4. Install the upper radiator hose to radiator. Align hose and position clamp so it will not interfere with the engine or the hood.
5. Connect negative cable to battery.
6. Fill cooling system.