Body Emblem: Service and Repair

EXTERIOR NAME PLATES

REMOVAL

1. Mark reference points before removing.
2. Using a heat gun gently apply heat in a circular motion to loosen the adhesive bond.
3. Using a nonmetallic prying device, such as a plastic or wood trim stick gently pry up at corners and remove.
4. Clean off all traces of adhesive or double sided tape from the panel with a general purpose adhesive remover.

INSTALLATION

1. Clean panel surface with isopropyl alcohol.
2. Align badgeing to reference points.
3. Install and press securely to full adhesive contact.
4. Clean away any reference points.