Keyless Entry Module: Service and Repair

REMOVAL

Battery Negative Cable Remove/Install:

1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel top cover.

RKE Module Location:

3. Remove the two screws holding the RKE module to the instrument panel assembly.
4. Slide locking tab of the wiring connector sideways to unlock tab, and remove connector from RKE module.
5. Remove RKE module from vehicle.

NOTE: When replacing a faulty RKE Module, the replacement module must be configured with the DRB Ill(R) scan tool for proper operation. Refer to Vehicle Theft/Security Systems, Switching Operating Modes/Configuring a New Module under Service Procedures. Additionally, all transmitters must be reprogrammed to the new RKE module.

INSTALLATION
For installation, reverse above the procedures.