Loss of Ignition Run/Start (Stored)

Test 4:

SYMPTOM
LOSS OF IGNITION RUN/START (STORED)

TEST NOTE
All symptoms listed above are diagnosed using the same tests. The title for the tests will be CLUSTER MESSAGE MISMATCH (STORED).

WHEN MONITORED
With the ignition in the run/start position the ACM monitors the Fused Ignition Switch Output Run/Start circuit for proper system voltage.

SET CONDITION
If the voltage on the Fused Ignition Switch Output Run/Start circuit drops below 4.5 volts, the code will set.

POSSIBLE CAUSES
- Stored code has become active
- Stored/active code has not been reproduced