Body Control Module: Service and Repair

REMOVAL
1. Remove the Junction Block/BCM from the vehicle. Refer to Power and Ground Distribution / Fuse Block / Service and Repair for Removal and Installation.
Service and Repair

2. Remove the four BCM attaching screws from the Junction Block.
3. Disconnect BCM from the Junction Block.

NOTE:
- The Remote Keyless Entry (RKE) module is attached to the BCM with three screws. This must be transferred (if equipped) to the new BCM.
- If the BCM is replaced, the Vehicle Theft/Security System (VTSS (if equipped) must be enabled in the new BCM via the DRB III in order to start the vehicle.

INSTALLATION
For installation, reverse the above procedures. Ensure that the wire terminals and connectors are in good condition and connectors are properly installed when reinstalling Junction Block/BCM.